Shooting heads Reversed Density (RD)
With this concept, sink-line fishing is made allot easier. These dual density lines have the Reverse Density compared to conventional shooting heads. Picking up and casting will be easier in running water. When the heavier rear end sinks, the lighter tip will be pushed down due to the water pressure. The heavier density close to your rod tip transfer more energy from your rod into the line. You might cast longer than ever before. Try it!
Sink-line casting made a lot easier
Easy lift and pick up of your sinking line
Casts equally well overhead and spey
Long flight & Smooth presentations
STEP 1: LETTING THE SHOOTING HEAD SINK
Our Reversed Density (RD) Shooting Heads have the higher density located towards the tip of the rod, letting the rear end of the line sink faster, then the tip end of the shooting head.
STEP 2: WATER CURRENT TAKES INN
When the shooting head is taken by the current, the lower density tip will be pulled down to the level of the higher density rear end. The result is better control over your fishing depth.
STEP 3: PICK-UP OF THE SHOOTING HEAD
The Reversed Density allows for easier Pick-Up of your line from running water; as only the lower density stays in the water under Pick-Up.
When spey-casting you will have the advantage of setting the anchor with the lower density tip.